Adductor Canal Block
Clinically reviewed by anesthesia providers · Updated
Goal
Put local anesthetic in the adductor canal to numb the saphenous nerve while leaving the quad working. That is the whole reason to pick this over a femoral block — the patient gets knee pain relief and can still stand and walk.
The catch: keep the injection low in the thigh and don't over-do the volume. Go too high and the local spreads to the motor branches, the quad goes weak, and you have lost the one advantage this block was for.
Local Anesthetic — Common Approaches
- Single shot: 10 mL of bupivacaine 0.15% is plenty; go up to 20 mL of 0.25% if you want a denser block. Lower volume keeps it quad-sparing.
- Continuous catheter (common for knee replacement): bupivacaine 0.15% or ropivacaine 0.2% at about 5 mL/hr.
- Confirm your agent, concentration, and volume against current ASRA guidance before you dose.
Indications
Reach for this on knee cases where you want pain control without a dead-weight leg. Total knee replacement is the classic one, along with ACL repair and other surgeries on the inner knee or medial lower leg.
It also finishes off a sciatic or popliteal block for the inner ankle and foot, and covers vein harvest along the medial leg. For a knee replacement, a catheter here is a workhorse for the days after surgery.
Common Indications
Anatomy
The adductor canal is a tunnel in the middle of the thigh, running under the sartorius muscle. Inside it sit the saphenous nerve, the nerve to vastus medialis, and the femoral artery and vein.
The saphenous nerve is purely sensory. The nerve to vastus medialis is the one motor branch you are trying to avoid — which is why where you inject matters more here than in most blocks.
Sonoanatomy
Linear probe across the inner thigh, about 3–5 cm deep. Find the femoral artery sitting right under the sartorius muscle and confirm it with color Doppler. The saphenous nerve is the small bright dot next to the artery.
Slide down the thigh to the lowest point where the artery is still tucked under sartorius. That low spot is what keeps the block quad-sparing.
Technique
Go in-plane and land the needle tip right next to the artery, inside the canal. You don't need to see the nerve — putting local in the right plane next to the artery is enough.
Aspirate, give a test dose, then inject and watch the spread. If it is tracking up the thigh you are too high, so reposition lower.
Complications & Pitfalls
The big one is quad weakness from injecting too high or with too much volume — it turns a walking block into a fall risk.
Otherwise the usual applies: hitting a vessel, local anesthetic toxicity, infection, bruising, and nerve irritation. If it won't inject easily, stop and reposition — never push against resistance.
Precautions & Contraindications
Skip it or think twice if you are worried about compartment syndrome, such as with a tibial fracture — the block can hide the pain that would warn you. Always run your maximum local anesthetic dose first.
The standard cautions apply: infection at the site, coagulopathy, and patient refusal. And even a motor-sparing block can leave some quad weakness, so tell the patient not to trust the leg for walking right away.
Pro Tips
- Go as low on the thigh as you can while the artery is still under sartorius.
- You don't have to see the nerve — the right plane next to the artery is enough.
- It is a sensory nerve, so you don't need a high concentration or a nerve stimulator.
- Scan up and down after injecting to check where the local actually went.
- Use color Doppler to dodge the small artery branches nearby.
- Pair it with a popliteal or sciatic block for the whole lower leg, or with an iPACK for the back of the knee.
Additional Notes
This block has largely replaced the femoral block for knee replacements. It controls pain while keeping the leg strong enough to get up and move, which is exactly what speeds recovery.